HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built from Jun 2009
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.CUSTOMER PROBLEM ANALYSIS |
| |||||
| 3.INSPECT BATTERY VOLTAGE |
- Standard Voltage:
- 11 to 14 V
| |||||
| 4.PROBLEM SYMPTOM CONFIRMATION |
| Result |
Proceed to |
| Symptom does not occur |
A |
| Symptom occurs |
B |
|
|||||
| |||||
| 5.SYMPTOM SIMULATION |
| |||||
| 6.CHECK DTC |
Check for DTCs and note any codes that are output (Click here).
Clear the DTC (Click here).
Recheck for DTCs. Try to prompt the DTC by simulating the original activity that the DTC suggests.
- NOTICE:
- The navigation receiver assembly may store the DTCs of the following system. If DTCs other than those specified in Diagnostic Trouble Code Chart of the rear view monitor system are output, refer to Diagnostic Trouble Code Chart for the applicable system.
System
Proceed to
Navigation System
Click here
Result Result
Proceed to
DTC is not output
A
DTC is output
B
|
|||||
| |||||
| 7.PROBLEM SYMPTOMS TABLE |
Refer to Problem Symptoms Table (Click here).
Result Result
Proceed to
Fault is not listed in Problem Symptoms Table
A
Fault is listed in Problem Symptoms Table
B
|
|||||
| |||||
| 8.BASED ON MALFUNCTION SYMPTOM, PERFORM TROUBLESHOOTING BELOW |
Refer to Terminals of ECU (Click here).
| |||||
| 9.DIAGNOSTIC TROUBLE CODE CHART |
Refer to Diagnostic Trouble Code Chart (Click here).
| |||||
| 10.CIRCUIT INSPECTION |
| |||||
| 11.ADJUST, REPAIR OR REPLACE |
| |||||
| 12.CONFIRMATION TEST |
| |||||