2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

TERMINALS OF ECU

System information · Vehicles built Oct 2006 – May 2009


TELEVISION CAMERA ASSEMBLY

  1. Disconnect the S17 camera connector.
    I035060E16

  2. Measure the voltage and resistance between each terminal of the wire harness side connector.

    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Value
    CGND (S17-3) - Body ground
    W - Body ground
    Ground
    Always
    Below 1 Ω
    CB+ (S17-4) - CGND (S17-3)
    B - W
    Power source
    Engine switch on (IG), shift lever R position
    5.50 to 7.05 V
    If the result is not as specified, there may be a malfunction on the wire harness side.

  3. Reconnect the S17 camera connector.

  4. Measure the voltage and frequency between each terminal of the connector.

    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Value
    CV+ (S17-2) - CV- (S17-1)
    R - Shielded
    Display signal
    Engine switch on (IG), shift lever R position
    See waveform 1
    If the result is not as specified, the camera may have a malfunction.

  5. E119731E01
    Reference:
    Oscilloscope waveform

    1. Waveform 1

      Item
      Content
      Measurement terminal
      CV+ - CV-
      Measurement setting
      0.2 V/DIV., 0.2 μS/DIV.
      Condition
      Engine switch on (IG), Shift lever R position


NAVIGATION RECEIVER (Click here)
← PROBLEM SYMPTOMS TABLE (Oct 2006 – May 2009)Reverse Signal Circuit (Oct 2006 – May 2009) →