2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Jun 2006


INSPECT CLOCK ASSEMBLY

  1. E128063E08
    Disconnect the F3 connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    F3-1 (B) - Body ground
    Always
    10 to 14 V
    F3-2 (ACC) - Body ground
    Ignition switch off
    Below 1 V
    Ignition switch on (IG)
    10 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    F3-19 (GND1) - Body ground
    Always
    Below 1 Ω

    HINT:
    If the value is not as specified, repair or replace the wire harness or connector.

← TERMINALS OF ECU (from Jun 2009)REMOVAL (Jun 2006 – Sep 2006) →