2006-2011 Camry Aurion · Service Manual TRANSMISSION

INSTALLATION

Removal / installation · Vehicles built Oct 2006 – May 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009


1. INSTALL SPEED SENSOR

  1. C138516E01
    Coat the 2 bolts with ATF.

  1. Install the speed sensor to the valve body with the 2 bolts.

    Torque:
    11 N*m{ 112 kgf*cm , 8 ft.*lbf }

  1. Connect the connector.


2. INSTALL TRANSMISSION VALVE BODY ASSEMBLY
  1. Coat the O-ring of the transmission wire with ATF.

  1. C161959E01
    Confirm that the manual valve lever is positioned as shown in the illustration and install the valve body assembly to the transaxle case with the 11 bolts.

    Torque:
    11 N*m{ 112 kgf*cm , 8 ft.*lbf }

    Bolt length:
    Bolt A:
    25 mm (0.98 in.)
    Bolt B:
    30 mm (1.18 in.)
    Bolt C:
    35 mm (1.38 in.)
    Bolt D:
    45 mm (1.77 in.)
    Bolt E:
    55 mm (2.17 in.)

    NOTICE:
    1. When installing the transmission valve body assembly, be careful not to allow the transmission revolution sensor and transaxle case to interfere with each other.
    2. Be sure to insert the pin of the manual valve lever into the groove on the end of the manual valve.
    3. First, temporarily tighten the bolts marked by (*1) in the illustration because they are positioning bolts.


3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY

  1. C136688E01
    Coat a new O-ring with ATF and install it to the oil strainer.

    NOTICE:
    Ensure that the O-ring is not twisted or pinched.

  1. C136687
    Install the oil strainer to the valve body with the 2 bolts.

    Torque:
    11 N*m{ 112 kgf*cm , 8 ft.*lbf }


4. INSTALL AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY

  1. C134963E02
    Install the 2 magnets to the oil pan.

  1. Install a new gasket to the oil pan.

  1. Apply adhesive to the 18 bolts.

    Adhesive:
    Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

  1. C134962
    Install the oil pan to the automatic transaxle with the 18 bolts.

    Torque:
    7.5 N*m{ 77 kgf*cm , 66 in.*lbf }

    NOTICE:
    1. In order to ensure proper sealing of the transmission oil pan bolts, apply adhesive to the bolts and install them within 10 minutes of adhesive application.
    2. Completely remove any oil or grease from the contact surface of the transaxle case and oil pan sub-assembly with the gasket before installation.


5. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY

HINT:
Click here.

← REMOVAL (from Jun 2009)INSTALLATION (from Jun 2009) →