2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

ON-VEHICLE INSPECTION

Inspection · Vehicles built Jun 2006 – May 2009

Versions by build date: Jun 2006 – May 2009 from Jun 2009


INSPECT AUTOMATIC LIGHT CONTROL SENSOR (for Manual Air Conditioning System)

  1. B109993E30
    Disconnect the E11 automatic light control sensor connector.

  1. Measure the voltage and resistance according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E11-3 (CLTB) - E11-6 (CLTE)
    Ignition switch OFF
    Below 1 V
    Ignition switch ON
    10 to 14 V

    Standard resistance:
    Tester Connection
    Specified Condition
    E11-6 (CLTE) - Body ground
    Below 1 Ω

    If the result is not as specified, there may be a malfunction on the wire harness side.

  1. Reconnect the automatic light control sensor connector.

  1. Connect an oscilloscope to the automatic light control sensor connector.

  1. B113714E01
    Check the waveform.

    OK:
    Tester Connection
    Tool Setting
    Condition
    Specified Condition
    E11-6 (CLTE) - E11-4 (CLTS)
    5 V/DIV., 5 ms./DIV
    Ignition switch ON, light control switch in AUTO
    Correct waveform is as shown

    HINT:
    If the ambient light becomes brighter, width A becomes narrower.

    If the result is not as specified, replace the automatic light control sensor.


INSPECT AUTOMATIC LIGHT CONTROL SENSOR (for Automatic Air Conditioning System)

  1. B109993E31
    Disconnect the E11 automatic light control sensor connector.

  1. Measure the voltage and resistance according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E11-6 (CLTB) - E11-3 (CLTE)
    Ignition switch OFF
    Below 1 V
    Ignition switch ON
    10 to 14 V

    Standard resistance:
    Tester Connection
    Specified Condition
    E11-3 (CLTE) - Body ground
    Below 1 Ω

    If the result is not as specified, there may be a malfunction on the wire harness side.

  1. Reconnect the automatic light control sensor connector.

  1. Connect an oscilloscope to the automatic light control sensor connector.

  1. B113714E01
    Check the waveform.

    OK:
    Tester Connection
    Tool Setting
    Condition
    Specified Condition
    E11-3 (CLTE) - E11-5 (CLTS)
    5 V/DIV., 5 ms./DIV
    Ignition switch ON, light control switch in AUTO
    Correct waveform is as shown

    HINT:
    If the ambient light becomes brighter, width A becomes narrower.

    If the result is not as specified, replace the automatic light control sensor.

← COMPONENTS (from Jun 2006)ON-VEHICLE INSPECTION (from Jun 2009) →