INSPECTION
Inspection · Vehicles built from Jun 2006
| INSPECT HEADLIGHT LEVELING SWITCH |
Measure the voltage of the switch.

Remove the headlight leveling switch.
Apply battery voltage to the headlight leveling switch connector.
Measure the voltage according to the value(s) in the table below.
- Standard voltage:
Measurement Condition
Tester Connection
Switch Condition
Specified Condition
(Battery voltage is 12 V)
Battery positive (+) → Terminal 1 (B)
Battery negative (-) → Terminal 4 (E)
2 (T) - 4 (E)
0
10.5 to 11.1 V
(0.5)
9.5 to 10.1 V
1
8.6 to 9.1 V
(1.5)
7.7 to 8.2 V
2
6.8 to 7.2V
(2.5)
5.8 to 6.2 V
3
4.9 to 5.2 V
(3.5)
4.0 to 4.2 V
4
3.0 to 3.2 V
(4.5)
2.1 to 22 V
5
1.1 to 1.3 V
Inspect the illumination of the switch.
Apply battery voltage to the headlight leveling switch connector.
Check that the illumination comes on.
- OK:
Measurement Condition
Specified Condition
Battery positive (+) → Terminal 3 (ILL+)
Battery negative (-) → Terminal 4 (E)
Illumination comes on
