INSTALLATION
Removal / installation · Vehicles built Oct 2006 – May 2009
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
| 1.
INSTALL FUEL PRESSURE PULSATION DAMPER ASSEMBLY |
 |
- Apply a light coat of gasoline or spindle oil to the O-ring of the fuel pressure pulsation damper.
- Install the fuel pressure pulsation damper with the 2 bolts.
-
Torque:
- 9.0 N*m{
92 kgf*cm
, 80 in.*lbf
}
- NOTICE:
- Make sure that the O-ring is not cracked or jammed before installing the damper.
| 2.
CONNECT FUEL TUBE SUB-ASSEMBLY |
 |
- HINT:
- Connect the metallic type connector (Click here).
| 3.
INSTALL AIR CLEANER CAP SUB-ASSEMBLY
|
 |
Install the air cleaner filter element onto the air cleaner case.
- Insert the hinges. Install the air cleaner cap sub-assembly with the 2 bolts.
- Connect the No. 1 air cleaner hose to the throttle body and unfasten the No. 1 air cleaner hose clamp.
- NOTICE:
- Match each concave area concavity of the air cleaner hose with the bolt of the throttle body.
- Make sure that the hose clamp is at the correct angle.
- Connect the No. 2 ventilation hose to the air cleaner hose.
- Connect the purge line hose to the clamp (*1).
Connect the 2 purge VSV vacuum hoses (*2).
Connect the purge VSV connector (*3).
Connect the mass air flow meter connector (*4).
| 4.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
|
| 5.
INSPECT FOR FUEL LEAK |
 |
- HINT:
-
Click here.
| 6.
INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY
|
 |
- Install the engine cover with the 2 nuts.
-
Torque:
- 9.0 N*m{
92 kgf*cm
, 80 in.*lbf
}