INSTALLATION
Removal / installation · Vehicles built Jun 2006 – Sep 2006
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
| 1.
INSTALL ECM |
 |
- Install the bracket to the ECM with the 4 screws.
-
Torque:
- 3.0 N*m{
30 kgf*cm
, 27 in.*lbf
}
- Install the ECM with the 3 bolts.
-
Torque:
- 8.0 N*m{
82 kgf*cm
, 71 in.*lbf
}
| 2.
CONNECT CONNECTOR |
 |
- Connect the 2 ECM connectors.
- NOTICE:
- When connecting the connector, make sure that dirt, water and other foreign matter does not get caught between the connector and other part.
Connect the 2 ECM connectors and lower the 2 levers.
- NOTICE:
- Make sure that the 2 levers are securely lowered.
| 3.
INSTALL AIR CLEANER CASE SUB-ASSEMBLY
|
 |
- Install the air cleaner case with the 3 bolts.
-
Torque:
- 5.0 N*m{
51 kgf*cm
, 44 in.*lbf
}
Connect the hose clamp.
| 4.
INSTALL AIR CLEANER CAP SUB-ASSEMBLY
|
 |
Install the air cleaner filter element onto the air cleaner case.
- Insert the hinges. Install the air cleaner cap sub-assembly with the 2 bolts.
- Connect the No. 1 air cleaner hose to the throttle body and unfasten the No. 1 air cleaner hose clamp.
- NOTICE:
- Match each concave area concavity of the air cleaner hose with the bolt of the throttle body.
- Make sure that the hose clamp is at the correct angle.
- Connect the No. 2 ventilation hose to the air cleaner hose.
- Connect the purge line hose to the clamp (*1).
Connect the 2 purge VSV vacuum hoses (*2).
Connect the purge VSV connector (*3).
Connect the mass air flow meter connector (*4).
| 5.
INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY
|
 |
- Install the engine cover with the 2 nuts.
-
Torque:
- 9.0 N*m{
92 kgf*cm
, 80 in.*lbf
}
| 6.
RESET MEMORY |
 |
When replacing the ECM, perform the RESET MEMORY procedure (A/T initialization) (Click here).