Home › ENGINE › 2AZ-FE CHARGING › GENERATOR
INSPECTION
Inspection · Vehicles built from Jun 2009
Versions by build date: Jun 2006 – May 2009 from Jun 2009
INSPECT GENERATOR BRUSH HOLDER ASSEMBLY
Using a vernier caliper, measure the brush length.
Standard length:
9.5 to 11.5 mm (0.374 to 0.453 in.)
Minimum length:
4.5 mm (0.177 in.)
If the brush length is less than the minimum, replace the generator brush holder assembly.
INSPECT GENERATOR ROTOR ASSEMBLY
Check the appearance. Check that the bearing is not rough or worn.
OK:
The bearing rotates smoothly.
If the result is not as specified, replace the generator rotor assembly.
Check the resistance.
Measure the resistance between the slip rings.
Standard Resistance:
Condition
Specified Condition
Approx. 20°C (68°F)
1.8 to 2.3 Ω
If the result is not as specified, replace the generator rotor assembly.
Measure the resistance between the slip ring and rotor core.
Standard Resistance:
Tester Connection
Specified Condition
Slip ring - Rotor core
1 MΩ or higher
If the result is not as specified, replace the generator rotor assembly.
Check the slip ring diameter. Using a vernier caliper, measure the slip ring diameter.
Standard diameter:
14.2 to 14.8 mm (0.559 to 0.583 in.)
Minimum diameter:
14 mm (0.551 in.)
If the diameter is less than the minimum, replace the generator rotor assembly.
INSPECT GENERATOR DRIVE END FRAME BEARING
Check that the bearing is not rough or worn.
OK:
The bearing rotates smoothly.
If the bearing does not rotate smoothly, replace the bearing.
INSPECT GENERATOR CLUTCH PULLEY (w/ Generator Clutch Pulley)
HINT:
Applicable only for models with generator clutch pulley.
Hold the center of the pulley, and confirm that the outer ring turns counterclockwise and does not turn clockwise. If the result is not as specified, replace the generator clutch pulley.