2006-2011 Camry Aurion · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Jun 2009

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE ENGINE UNDER COVER RH

3. REMOVE ENGINE UNDER COVER LH

4. DRAIN ENGINE COOLANT

NOTICE:
Do not remove the radiator cap sub-assembly while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Remove the radiator cap sub-assembly from the radiator assembly.

  1. Loosen the radiator drain cock plug and cylinder block drain cock plug, then drain the coolant.

    A136224E04

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.


5. REMOVE FRONT FENDER APRON SEAL RH

6. REMOVE NO. 2 ENGINE MOUNTING STAY RH

  1. A134912
    Remove the 2 bolts and No. 2 engine mounting stay RH.


7. REMOVE ENGINE MOVING CONTROL ROD SUB-ASSEMBLY

  1. A134909
    Remove the bolt and disconnect the ground cable.

  1. A134910
    Remove the 3 bolts and engine moving control rod sub-assembly.


8. REMOVE NO. 2 ENGINE MOUNTING BRACKET RH

  1. A134911
    Remove the 3 bolts and No. 2 engine mounting bracket RH.


9. REMOVE V-RIBBED BELT

  1. A114351E03
    Using SST and a 19 mm socket wrench, loosen the V-ribbed belt tensioner arm clockwise, then remove the V-ribbed belt.
    SST
    09216-42010  

    NOTICE:
    1. Be sure to connect SST and the tools so that they are in line during use.
    2. When retracting the tensioner, turn it clockwise slowly for 3 seconds or more. Do not apply force rapidly.
    3. After the tensioner is fully retracted, do not apply more force than necessary.


10. REMOVE GENERATOR ASSEMBLY

  1. A135170
    Disconnect the generator connector.

  1. Remove the nut and disconnect the wire harness from terminal B.

  1. Remove the bolt and wire harness clamp bracket.

  1. Remove the wire harness clamp.

  1. A142104
    Remove the 2 bolts and generator assembly.


11. REMOVE WATER PUMP PULLEY

A098715E03
  1. Using SST, remove the 4 bolts and water pump pulley.

    SST
    09960-10010   (09962-01000, 09963-00700)


12. REMOVE WATER PUMP ASSEMBLY

A094516E01
  1. Remove the clamp of the crankshaft position sensor from the water pump.

  1. Disconnect the wire of the crankshaft position sensor from the clamp bracket.

  1. B012052E03
    Remove the 4 bolts, 2 nuts and clamp bracket.

  1. A129792
    Using a screwdriver, pry between the water pump and cylinder block, and then remove the water pump.

    HINT:
    Tape the screwdriver tip before use.

    NOTICE:
    Be careful not to damage the contact surfaces of the water pump and cylinder block.

← REMOVAL (Oct 2006 – May 2009)INSPECTION (from Jun 2006) →