INSPECTION
Inspection · Vehicles built from Jun 2006
| INSPECT STEERING PAD SWITCH (for 4 Spoke) |
Remove the steering pad switch.


Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
a1- 7 (+DP) - a1-2 (EAU)
DISP switch is not pushed in.
10 kΩ or higher
a1- 7 (+DP) - a1-2 (EAU)
DISP switch is pushed in.
Below 1 Ω
- HINT:
- If the value is not as specified, replace the steering pad switch.
| REMOVE STEERING PAD SWITCH (for 3 Spoke) |
Remove the steering pad switch.


Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
a1- 7 (+DP) - a1-8 (EAU)
DISP switch is not pushed in.
10 kΩ or higher
a1- 7 (+DP) - a1-8 (EAU)
DISP switch is pushed in.
Below 1 Ω
- HINT:
- If the value is not as specified, replace the steering pad switch.
