INSPECTION
Inspection · Vehicles built from Jun 2006
| INSPECT PACK CLEARANCE OF FORWARD CLUTCH |
Install the forward clutch on the oil pump.

- NOTICE:
- Be careful not to damage the oil seal ring of the oil pump.
Using a dial indicator, measure the forward clutch pack clearance while applying and releasing compressed air (392 kPa, 4.0 kgf/cm2, 57 psi).
- Pack clearance:
- 1.00 to 1.25 mm (0.0394 to 0.04921 in.)
If the piston stroke is less than the minimum, parts may have been assembled incorrectly. Check and reassemble again.- HINT:
- As the opening is large, cover it with a piece of cloth or shop rag to prevent the compressed air from being released.
- There are 5 flanges of different thicknesses.
- As the opening is large, cover it with a piece of cloth or shop rag to prevent the compressed air from being released.
Flange thickness: mm (in.) No.
Thickness
No.
Thickness
1
3.00 (0.1181)
4
3.45 (0.1358)
2
3.15 (0.1240)
5
3.60 (0.1417)
3
3.30 (0.1299)
-
-
| INSPECT FORWARD MULTIPLE DISC CLUTCH DISC |
Check if the sliding surfaces of the discs, plates, and flange are worn or burnt.

If necessary, replace them.- HINT:
- If the lining of a disc comes off or discolors, or even if a part of the groove is damaged, replace all discs.
- Before assembling new discs, soak them in ATF for at least 15 minutes.
- If the lining of a disc comes off or discolors, or even if a part of the groove is damaged, replace all discs.
| INSPECT FORWARD CLUTCH RETURN SPRING SUB-ASSEMBLY |
Using vernier calipers, measure the free length of the spring together with the spring seat.

- Standard free length:
- 26.74 mm (1.0528 in.)
| INSPECT FORWARD MULTIPLE DISC CLUTCH DISC |
Check if the disc lightly rotates when rotating the forward clutch assembly after inserting the multiple disc clutch into it.

- NOTICE:
- Do not place the forward clutch assembly in a vise.
