INSPECTION
Inspection · Vehicles built Jun 2006 – Sep 2006
| INSPECT HAZARD WARNING SIGNAL SWITCH ASSEMBLY |
Measure the resistance according to the value(s) in the table below.

- Standard resistance:
Tester Connection
Condition
Specified Condition
5 - 4
OFF
10 kΩ or higher
5 - 4
ON
Below 1 Ω
Apply battery voltage to the hazard warning signal switch assembly connector.
- OK:
Measurement Condition
Specified Condition
Battery positive (+) → Terminal 7
Battery negative (-) → Terminal 8
Illumination comes on
