2006-2011 Camry Aurion · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built Oct 2006 – May 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. DRAIN ENGINE COOLANT

NOTICE:
Do not remove the radiator cap sub-assembly while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Remove the radiator cap sub-assembly from the radiator assembly.

  1. Loosen the radiator drain cock plug and 2 cylinder block drain cock plugs, then drain the coolant.

    A128117E02

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.


3. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
(Click here)

4. REMOVE COWL TOP OUTER FRONT PANEL SUB-ASSEMBLY

  1. C141972E01
    Disengage the clamp.

  1. Remove the 4 nuts, the 4 bolts and the cowl top outer front panel sub-assembly.


5. REMOVE V-BANK COVER SUB-ASSEMBLY

  1. A140800
    Hold the front of the V-bank cover and raise it to disengage the 2 clips on the front of the cover. Continue to raise the cover to disengage the clip on the rear of the cover and remove the cover.

    NOTICE:
    Attempting to disengage both front and rear clips at the same time may cause the cover to break.


6. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

  1. A135704
    Disconnect the 3 vacuum hoses.

  1. A135705E01
    Disconnect the mass air flow meter connector (*1).

  1. Disconnect the No. 2 ventilation hose (*2).

  1. Disconnect the hose band (*3).

  1. A135706
    Disconnect the 3 bands, and remove the air cleaner cap sub-assembly.


7. REMOVE INTAKE AIR SURGE TANK ASSEMBLY

  1. A129464E01
    Disconnect the 2 water by-pass hoses from the throttle with motor body assembly.

  1. Disconnect the vapor feed hose.

  1. Disconnect the throttle with motor body assembly connector and clamp.

  1. Disconnect the No. 1 ventilation hose.

  1. A129466
    Remove the bolt and vacuum hose clamp.

  1. A129467
    Disconnect the connector.

  1. Remove the 4 bolts, No. 1 surge tank stay and throttle body bracket.

  1. A139209E01
    Using a 5 mm socket hexagon wrench, remove the 4 bolts.

  1. Remove the 2 nuts and intake air surge tank.

  1. Remove the gasket from the intake air surge tank.


8. REMOVE NO. 1 SURGE TANK STAY

  1. A136114
    Remove the bolt and disconnect the harness clamp.

  1. A134967
    Remove the bolt and No. 1 surge tank stay.


9. REMOVE IGNITION COIL ASSEMBLY

  1. A134966E01
    Disconnect the 6 ignition coil connectors.

  1. Remove the 6 bolts and 6 ignition coils.

← COMPONENTS (from Oct 2006)REMOVAL (from Jun 2009) →