2006-2011 Camry Aurion · Service Manual COMMUNICATION SYSTEM

Combination Meter ECU Communication Stop Mode

Circuit diagnosis · Vehicles built from Oct 2006

DESCRIPTION

Detection Item
Symptom
Trouble Area
Combination Meter ECU Communication Stop Mode
  1. "Combination Meter" is not displayed on the "Communication Bus Check" screen of the intelligent tester
  2. Applies to "Combination Meter ECU Communication Stop Mode" in the "DTC COMBINATION TABLE"
  1. Power source circuit of the combination meter
  2. Combination meter main wire or connector
  3. Combination meter

WIRING DIAGRAM

C126214E14

INSPECTION PROCEDURE

NOTICE:
  1. Turn the ignition switch off before measuring the resistances of CAN main wires and CAN branch wires.
  2. After the ignition switch is turned off, check that the key reminder warning system and lighting system are not operating.
  3. Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any other switches or the doors. If doors need to be opened in order to check connectors, open the doors and leave them open.

HINT:
Operating the ignition switch, any other switches, or any doors triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.


1. CHECK FOR OPEN IN CAN BUS WIRE (COMBINATION METER MAIN BUS WIRE)

  1. C133243E04
    Turn the ignition switch off.

  1. Disconnect the combination meter connector.

  1. C133243E05
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    2AZ-FE:
    Tester Connection
    Condition
    Specified Condition
    F1-23 (CANH) - F1-22 (CANL)
    Ignition switch off
    108 to 132 Ω

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    2GR-FE:
    Tester Connection
    Condition
    Specified Condition
    F1-17 (CANH) - F1-18 (CANL)
    Ignition switch off
    108 to 132 Ω



NG
REPAIR OR REPLACE CAN BUS MAIN WIRE OR CONNECTOR (COMBINATION METER MAIN BUS WIRE)
OK


2. CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT)

  1. C133243E02
    Disconnect the combination meter connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    F1-24 (ES) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    F1-13 (IG+) - Body ground
    Ignition switch on
    10 to 14 V
    F1-2 (B2) - Body ground
    Always
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE COMBINATION METER ASSEMBLY


← Main Body ECU Communication Stop Mode (from Oct 2006)Center Airbag Sensor Communication Stop Mode (from Oct 2006) →