Air Conditioning Amplifier Communication Stop Mode
Circuit diagnosis · Vehicles built from Oct 2006
DESCRIPTION
| Detection Item |
Symptom |
Trouble Area |
| Air Conditioning Amplifier Communication Stop Mode |
|
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- Turn the ignition switch off before measuring the resistance of the CAN main wire and CAN branch wires.
- After the ignition switch is turned off, check that the key reminder warning system and lighting system are not operating.
- Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any other switches or the doors. If doors need to be opened in order to check connectors, open the doors and leave them open.
- Turn the ignition switch off before measuring the resistance of the CAN main wire and CAN branch wires.
- HINT:
- Operating the engine switch, any other switches, or any doors triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.
| 1. CHECK CAN BUS LINE FOR DISCONNECTION (AIR CONDITIONING AMPLIFIER BRANCH WIRE) |
Turn the ignition switch off.

Disconnect the air conditioning amplifier connector.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
E38-11 (CANH) - E38-12 (CANL)
Ignition Switch off
54 to 69 Ω
|
|
||||
| OK | |
| 2. CHECK HARNESS AND CONNECTOR (IG+, B, GND) |
Disconnect the air conditioning amplifier connector.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
E38-14 (GND) - Body Ground
Always
Below 1 Ω
Measure the voltage according to the value(s) in the table below.
- Standard voltage:
Tester Connection
Condition
Specified Condition
E38-1 (IG+) - Body Ground
Ignition Switch on
10 to 14 V
E38-21 (B)- Body Ground
Always
10 to 14 V
|
|
||||
| OK | ||
| ||
