2006-2011 Camry Aurion · Service Manual SECURITIES

ECU Power Source Circuit

Circuit diagnosis · Vehicles built from Jun 2009

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009

DESCRIPTION

This circuit provides power to operate the transponder key ECU assembly.

WIRING DIAGRAM

B150849E02

INSPECTION PROCEDURE

NOTICE:
If the transponder key ECU assembly is replaced, register the key and ECU communication ID.


1. CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - BATTERY)

  1. B128337E02
    Disconnect the E15 ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E15-1 (+B) - Body ground
    Always
    10 to 14 V
    E15-2 (IG) - Body ground
    Ignition switch OFF
    Below 1 V
    Ignition switch ON
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR, OR REPLACE FUSE
OK


2. CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - BODY GROUND)

  1. B128337E03
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E15-16 (GND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← ECU Power Source Circuit (Oct 2006 – May 2009)Diagnosis Circuit (Jun 2006 – Sep 2006) →