2006-2011 Camry Aurion · Service Manual SECURITIES

B2797 Communication Malfunction No. 1

Diagnostic trouble codes · Vehicles built from Jun 2009

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009

DESCRIPTION

This DTC is output when an error occurs in communication between the transponder key amplifier and the transponder key ECU.

HINT:
Some noise is found in the communication line.

DTC No.
DTC Detection Condition
Trouble Area
B2797
Keys are positioned too close to each other, or noise occurs in communication line
  1. Key
  2. Transponder key amplifier
  3. Transponder key ECU assembly

WIRING DIAGRAM

B052550E26

INSPECTION PROCEDURE

NOTICE:
If the transponder key ECU assembly is replaced, register the key and ECU communication ID.


1. CHECK KEYS

  1. B072873E02
    Check whether the ignition key being used is near other ignition keys, as shown in the illustration. Also, check whether the key ring is in contact with the key grip.

    Result:
    Result
    Proceed to
    Key is near other keys and/or key ring is in contact with key grip.
    A
    Key is not near other keys and/or key ring is not in contact with key grip.
    B



B
Go to step 3
A


2. CHECK DTC OUTPUT
  1. Separate the keys from each other, or remove the key ring.

  1. Delete the DTCs (Click here).

  1. Insert a key into the ignition key cylinder and remove the key. Repeat for all the other keys of the vehicle.

    OK:
    No code is output.



OK
END
NG


3. CHECK TRANSPONDER KEY AMPLIFIER
  1. After replacing the transponder key amplifier (Click here) with a normally functioning amplifier, check that the engine starts.

    OK:
    The engine starts.



NG
REPLACE TRANSPONDER KEY ECU ASSEMBLY
OK

END


← B2797 Communication Malfunction No. 1 (Oct 2006 – May 2009)B2799 Engine Immobiliser System Malfunction (Jun 2006 – Sep 2006) →