B2780 Push Switch / Key Unlock Warning Switch Malfunction
Diagnostic trouble codes · Vehicles built from Jun 2009
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
DESCRIPTION
This DTC will be output if the transponder key ECU assembly does not detect that the unlock warning switch is ON even when the ignition switch is in the ON position. Under normal conditions, the unlock warning switch assembly is ON when the ignition switch is in the ON position.| DTC No. |
DTC Detection Condition |
Trouble Area |
| B2780 |
"Unlock warning switch ON" is not detected when ignition switch is ON |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- If the transponder key ECU assembly is replaced, register the key and ECU communication ID.
| 1. READ VALUE ON INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.

Turn the ignition switch to the ON position and turn the intelligent tester main switch on.
Select Key SW in the DATA LIST and read the tester display.
IMMOBILISER: Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Key SW
Unlock warning switch signal/ON or OFF
ON: Key is in ignition key cylinder
OFF: No key is in ignition key cylinder
-
- OK:
- ON (Key is in ignition key cylinder) appears on the screen.
|
|
||||
| NG | |
| 2. INSPECT UNLOCK WARNING SWITCH ASSEMBLY |
Remove the unlock warning switch assembly (Click herefor 2AZ-FE, Click here for 2GR-FE)).

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Switch Position
Specified Condition
1 - 2
Switch pushed
(Key set)
Below 1 Ω
Switch free
(Key removed)
10 kΩ or higher
- Result:
Result
Proceed to
NG (for 2AZ-FE)
A
NG (for 2GR-FE)
B
OK
C
|
|
||||
|
|
||||
| C | |
| 3. CHECK HARNESS AND CONNECTOR (UNLOCK WARNING SWITCH - BODY GROUND) |
Measure the resistance according to the value(s) in the table below.

- Standard resistance:
Tester Connection
Condition
Specified Condition
E22-2 - Body ground
Always
Below 1 Ω
|
|
||||
| OK | |
| 4. CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - UNLOCK WARNING SWITCH) |
Disconnect the E15 ECU connector.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
E15-3 (KSW) - E22-1
Always
Below 1 Ω
E22-1 - Body ground
10 kΩ or higher
|
|
||||
| OK | ||
| ||
