2006-2011 Camry Aurion · Service Manual SECURITIES

B2784 Antenna Coil Open / Short

Diagnostic trouble codes · Vehicles built Oct 2006 – May 2009

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009

DESCRIPTION

The transponder key coil is built into the transponder key amplifier and receives a key code signal from the transponder chip in the key. This signal is amplified by the amplifier, then it is output to the transponder key ECU assembly.
DTC No.
DTC Detection Condition
Trouble Area
B2784
Antenna coil is open/shorted
  1. Wire harness
  2. Transponder key amplifier
  3. Transponder key ECU assembly

WIRING DIAGRAM

B111588E21

INSPECTION PROCEDURE

NOTICE:
If the transponder key ECU assembly is replaced, register the key and ECU communication ID.


1. READ VALUE ON INTELLIGENT TESTER

  1. B139188E02
    Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to the ON position and turn the intelligent tester on.

  1. Select Antenna Coil Status in the DATA LIST and read the intelligent tester display.

    IMMOBILISER: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Antenna Coil Status
    Transponder key amplifier coil condition/NORMAL or FAIL
    NORMAL: Antenna coil is normal
    FAIL: Antenna coil is malfunctioning
    -

    OK:
    NORMAL (Antenna coil is normal) appears on the screen.



OK
REPLACE TRANSPONDER KEY ECU ASSEMBLY
NG


2. CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - TRANSPONDER KEY AMPLIFIER)

  1. B124193E03
    Disconnect the E15 ECU and E25 amplifier connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E15-4 (TXCT) - E25-5 (TXCT)
    Always
    Below 1 Ω
    E15-5 (AGND) - E25-7 (AGND)
    E15-14 (VC5) - E25-1 (VC5)
    E15-15 (CODE) - E25-4 (CODE)
    E15-4 (TXCT) - Body ground
    10 kΩ or higher
    E15-5 (AGND) - Body ground
    E15-14 (VC5) - Body ground
    E15-15 (CODE) - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. INSPECT TRANSPONDER KEY ECU ASSEMBLY (TRANSPONDER KEY AMPLIFIER POWER SOURCE)

  1. B128338E01
    Reconnect the E15 ECU and E25 amplifier connectors.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E15-14 (VC5) - Body ground
    No key is in ignition key cylinder
    Below 1 V
    Key is in ignition key cylinder
    4.6 to 5.4 V



NG
REPLACE TRANSPONDER KEY ECU ASSEMBLY
OK


4. INSPECT TRANSPONDER KEY ECU ASSEMBLY (TRANSPONDER KEY AMPLIFIER GROUND)

  1. B128338E02
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E15-5 (AGND) - Body ground
    Always
    Below 1 Ω



NG
REPLACE TRANSPONDER KEY ECU ASSEMBLY
OK

REPLACE TRANSPONDER KEY AMPLIFIER (Click here)


← B2784 Antenna Coil Open / Short (Jun 2006 – Sep 2006)B2784 Antenna Coil Open / Short (from Jun 2009) →