DATA LIST / ACTIVE TEST
System information · Vehicles built from Jun 2006
| READ DATA LIST |
- HINT:
- Using the DATA LIST displayed on the intelligent tester, the values of the switches, sensors, actuators, etc. can be checked without part removal. Reading the DATA LIST as the first step in troubleshooting is one way to shorten labor time.
Connect the intelligent tester to the DLC3.

Turn the ignition switch to the ON position.
Read the DATA LIST according to the display on the tester.
IMMOBILISER: Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Key SW
Unlock warning switch signal/ON or OFF
ON: Key is in ignition key cylinder
OFF: No key is in ignition key cylinder
-
IG SW
Ignition switch signal/ON or OFF
ON: Ignition switch ON or START
OFF: Ignition switch ACC or OFF
-
Immobiliser
Immobiliser system status/SET or UNSET
UNSET: Ignition switch ON
SET: Without key
-
Permit (Start)
Permit (Start) signal/OK or NG
NG: No permission for engine start
OK: Engine start permission
-
Response
Transponder chip data/NG or OK
NG: Data error
OK: Data OK
-
Frame Error
Transponder chip data/NG or OK
NG: Data error
OK: Data OK
-
Different Serial Number
Transponder chip data/NG or OK
NG: Data error
OK: Data OK
-
Different Encrypt Code
Transponder chip data/NG or OK
NG: Data error
OK: Data OK
-
Abnormal Status
Transponder chip data/NG or OK
NG: Data error
OK: Data OK
-
Bcc Malfunction
Transponder chip data/NG or OK
NG: Incorrect data being sent
OK: Correct data being sent
-
Sub Key
Sub key code signal/NOMATCH or MATCH
NOMATCH: Non-matching sub key code is sent
MATCH: Sub key code is sent
-
Master Key
Master key code signal/NOMATCH or MATCH
NOMATCH: Non-matching master key code is sent
MATCH: Master key code is sent
-
Transponder S-Code
Number of registered sub key/min. 0, max. 15
Number of registered sub key
-
Transponder M-Code
Number of registered master key/min. 0, max. 15
Number of registered master key
-
Reg Code Space Full
Memory space for key codes registration/NOT FULL or FULL
NOT FULL: More key code registration possible
FULL: No more key code registration possible
-
+B
Power source/BRAKE or NORMAL
BRAKE: Power source open
NORMAL: Power source normal
-
Antenna Coil Status
Transponder key amplifier coil condition/NORMAL or FAIL
NORMAL: Antenna coil is normal
FAIL: Antenna coil is malfunctioning
-
| PERFORM ACTIVE TEST |
- HINT:
- Performing the intelligent tester ACTIVE TEST allows a relay, VSV, actuator and other items to be operated without removing any parts. Performing the ACTIVE TEST early in troubleshooting is one way to shorten labor time. The DATA LIST can be displayed during the ACTIVE TEST.
Connect the intelligent tester to the DLC3.

Turn the ignition switch to the ON position.
Perform the ACTIVE TEST according to the display on the tester.
IMMOBILISER: Tester Display
Test Part
Control Range
Diagnostic Note
Security Indic
Turn security indicator
ON/OFF
-