REASSEMBLY
Removal / installation · Vehicles built Jun 2006 – Sep 2006
| 1. INSTALL NO. 1 COOLER THERMISTOR |
If using a new evaporator:
Install the No. 1 cooler thermistor to the evaporator as shown in the illustration.

If reusing the evaporator:
Install the No. 1 cooler thermistor to the evaporator as shown in the illustration.

| 2. INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY |
Sufficiently apply compressor oil to 2 new O-rings and the fitting surfaces. Install the 2 O-rings to the No. 1 cooler evaporator sub-assembly.

- Compressor oil:
- ND-OIL 8 or equivalent
Install the No. 1 cooler evaporator sub-assembly.

| 3. INSTALL HEATER RADIATOR UNIT SUB-ASSEMBLY |
Install the heater radiator unit sub-assembly to the air conditioner radiator assembly.

Install the clamp with the screw.

Engage the 4 claws and install the heater clamp.
| 4. INSTALL AIR MIX CONTROL SERVO MOTOR (for Automatic Air Conditioning System) |
Install the air mix control servo motor with the 2 screws.

| 5. INSTALL AIR OUTLET CONTROL SERVO MOTOR |
Install the air outlet control servo motor with the 3 screws.

Connect the 2 connectors and install the air conditioner harness.

| 6. INSTALL DRAIN COOLER HOSE |
Install the drain cooler hose to the air conditioner radiator assembly.

| 7. INSTALL NO. 6 HEATER TO REGISTER DUCT ASSEMBLY |
Engage the 4 claws to install the No. 6 heater to register duct assembly.

| 8. INSTALL BLOWER ASSEMBLY |
Install the blower assembly with the 6 screws.

Connect the connector.

| 9. INSTALL COOLER EXPANSION VALVE |
Using a 4 mm hexagon wrench, install the cooler expansion valve with the 2 hexagon bolts.

- Torque:
- 3.5 N*m{ 35 kgf*cm , 30 in.*lbf }
| 10. INSTALL NO. 2 AIR DUCT SUB-ASSEMBLY |
Engage the 2 claws to install the No. 2 air duct sub-assembly.

