2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

Door Key Lock / Unlock Switch Circuit

Circuit diagnosis · Vehicles built from Jun 2006

DESCRIPTION

The door lock and unlock switch is built into the front passenger door lock assembly.
This switch is ON when the door key is in the unlock position and OFF when the door key is in the lock position. It is used as one of the operating conditions for the key confinement prevention function.

WIRING DIAGRAM

B109774E19

INSPECTION PROCEDURE


1. INSPECT FRONT DOOR LOCK ASSEMBLY RH (DOOR KEY LOCK AND UNLOCK SWITCH)

  1. B112613E04
    Remove the front door lock assembly RH.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    5 - 8
    ON
    (Door lock set to UNLOCK)
    Below 1 Ω
    5 - 8
    6 - 8
    OFF (Free)
    10 kΩ or higher
    6 - 8
    ON
    (Door lock set to LOCK)
    Below 1 Ω



NG
REPLACE FRONT DOOR LOCK ASSEMBLY RH
OK


2. CHECK WIRE HARNESS (FRONT DOOR LOCK RH - MAIN BODY ECU (INSTRUMENT PANEL J/B))

  1. Disconnect the IJ J/B connector.B138032E04

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection (Symbols)
    Condition
    Specified Condition
    H8-6 (L) - IJ-5
    Always
    Below 1 Ω
    H8-5 (UL) - IK-7
    Always
    Below 1 Ω
    H8-8 (E) - Body ground
    Always
    Below 1 Ω
    H8-6 (L) - Body ground
    Always
    10 kΩ or higher
    H8-5 (UL) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE


← Luggage Compartment Door Lock Circuit (from Jun 2006)Driver Side Door Key Lock and Unlock Switch Circuit (from Jun 2006) →