2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

Door Key Lock / Unlock Switch Circuit

Circuit diagnosis · Vehicles built from Jun 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009

DESCRIPTION

The door lock and unlock switch is built into the door lock assembly.
This switch is ON when the door key is in the unlock position and OFF when the door key is in the lock position. It is used as one of the operating conditions for the key confinement prevention function.

WIRING DIAGRAM

B109774E25

INSPECTION PROCEDURE


1. INSPECT FRONT DOOR LOCK ASSEMBLY RH (DOOR KEY LOCK AND UNLOCK SWITCH)

  1. B112613E01
    Remove the front door lock assembly RH (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    5 - 8
    ON
    (Door lock set to UNLOCK)
    Below 1 Ω
    5 - 8
    6 - 8
    OFF (Free)
    10 kΩ or higher
    6 - 8
    ON
    (Door lock set to LOCK)
    Below 1 Ω



NG
REPLACE FRONT DOOR LOCK ASSEMBLY LH (Click here)
OK


2. CHECK HARNESS AND CONNECTOR (FRONT DOOR LOCK RH - INSTRUMENT PANEL J/B)

  1. Disconnect the instrument panel J/B connector.B138063E01

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection (Symbols)
    Condition
    Specified Condition
    H8-6 (L) - IJ-5
    Always
    Below 1 Ω
    H8-5 (UL) - IK-7
    Always
    Below 1 Ω
    H8-8 (E) - Body ground
    Always
    Below 1 Ω
    H8-6 (L) - Body ground
    Always
    10 kΩ or higher
    H8-5 (UL) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Door Key Lock / Unlock Switch Circuit (Oct 2006 – May 2009)Driver Side Door Key Lock and Unlock Switch Circuit (Oct 2006 – May 2009) →