2006-2011 Camry Aurion · Service Manual ENGINE

DISASSEMBLY

Removal / installation · Vehicles built from Jun 2006


1. REMOVE DRAIN PLUG
  1. Remove the drain plug.

  1. Remove the O-ring.


2. REMOVE RADIATOR TANK UPPER

  1. A104619E05
    Install the claw to the overhaul handle, inserting it in the hole in part A as shown in the illustration.
    SST
    09230-01010   (09231-01010, 09231-01030)

  1. While gripping the handle, adjust the stopper bolt so that dimension B is as shown in the illustration.

    Dimension B:
    0.2 to 0.3 mm (0.008 to 0.012 in.)

    NOTICE:
    If the stopper bolt is not adjusted, the claw may be damaged.

  1. A128137E02
    Using SST to release the caulking, grip the handle until stopped by the stopper bolt.
    SST
    09230-01010   (09231-01010, 09231-01030)

  1. A128138E01
    Lightly tap the bracket of the radiator (or radiator hose inlet or outlet) with a soft-faced hammer and remove the tank.

  1. Remove the O-ring.


3. REMOVE RADIATOR TANK LOWER

  1. A134968E07
    Remove the bolt, 2 clips and hose from the radiator assembly.

  1. Removal procedure of the radiator tank lower is the same as that of the radiator tank upper.

← REMOVAL (from Jun 2009)INSPECTION (from Jun 2006) →