INSTALLATION
Removal / installation · Vehicles built from Jun 2009
Versions by build date: Jun 2006 – May 2009 from Jun 2009
| 1.
INSTALL FUEL SUCTION TUBE ASSEMBLY WITH PUMP AND GAUGE |
 |
- Install a new gasket to the fuel suction tube.
Install the fuel suction tube.
- NOTICE:
- Do not damage the fuel pump filter.
- Be careful that the arm of the sender gauge does not bend.
| 2.
INSTALL FUEL TANK VENT TUBE SET PLATE |
 |
- Align the mark of the set plate with the fuel suction tube.
Install the set plate with the 8 bolts.
-
Torque:
- 5.9 N*m{
60 kgf*cm
, 52 in.*lbf
}
| 3.
CONNECT FUEL PUMP TUBE SUB-ASSEMBLY |
 |
- Install the fuel pump tube with the tube joint clip.
- NOTICE:
- Check that there are no scratches or foreign objects on the connecting part.
- Check that the fuel tube joint is inserted securely.
- Check that the tube joint clip is on the collar of the fuel tube joint.
- After installing the tube joint clip, check that the fuel tube joint cannot be pulled off.
| 4.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
|
| 5.
INSTALL REAR FLOOR SERVICE HOLE COVER |
 |
- Connect the fuel pump connector.
Install the rear floor service hole cover with new butyl tape.
| 6.
INSPECT FOR FUEL LEAK |
 |
- HINT:
-
Click here.
| 7.
INSTALL REAR SEAT CUSHION ASSEMBLY (for Fixed Type)
|
 |
- Attach the 2 front hooks of the seat cushion to the vehicle body.
Confirm that the seat cushion is firmly installed.
- NOTICE:
- When installing the seat cushion, make sure the seat belt buckle is not under the seat cushion.
| 8.
INSTALL REAR SEAT CUSHION ASSEMBLY (for Fold Down Seat Type)
|
 |
- Attach the front hooks of the bench type rear seat cushion assembly to the vehicle body.
Confirm that the seat cushion is firmly installed.
- NOTICE:
- When installing the bench type rear seat cushion assembly, make sure that the seat belt buckle is not under the bench type rear seat cushion assembly.