ON-VEHICLE INSPECTION
Inspection · Vehicles built from Jun 2009
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
| SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY
|
 |
- Remove the 2 bolts and separate the front disc brake caliper assembly from the steering knuckle.
- NOTICE:
- Use wire or an equivalent tool to keep the brake caliper from hanging down by the flexible hose.
| REMOVE FRONT DISC
|
 |
- Remove the front disc.
- HINT:
- Put matchmarks on the disc and the axle hub.
| INSPECT FRONT AXLE HUB BEARING LOOSENESS |
 |
- Using a dial indicator, check for looseness near the center of the axle hub.
- Maximum:
- 0.05 mm (0.0020 in.)
- NOTICE:
- Ensure that the dial indicator is set perpendicular to the measurement surface.
- HINT:
- If looseness exceeds the maximum, replace the bearing.
| INSPECT FRONT AXLE HUB RUNOUT |
 |
- Using a dial indicator, check for runout on the surface of the axle hub outside the hub bolt.
- Maximum:
- 0.05 mm (0.0020 in.)
- NOTICE:
- Ensure that the dial indicator is set perpendicular to the measurement surface.
- HINT:
- If runout exceeds the maximum, replace the axle hub.
| INSTALL FRONT DISC
|
 |
- Align the matchmarks and install the front disc.
- NOTICE:
- When replacing the disc with a new one, select the installation position where the front disc has the minimum runout.
| INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY
|
 |
- Install the front disc brake caliper assembly to the steering knuckle with the 2 bolts.
-
Torque:
- 107 N*m{
1,090 kgf*cm
, 79 ft.*lbf
}
- NOTICE:
- Do not twist the brake hose when installing the front disc brake caliper assembly.
| INSTALL FRONT WHEEL |
 |
-
Torque:
- 103 N*m{
1,050 kgf*cm
, 76 ft.*lbf
}