2006-2011 Camry Aurion · Service Manual SUSPENSION & AXLE

INSTALLATION

Removal / installation · Vehicles built from Jun 2009

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009


1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY

  1. C083035E02
    Install the hub and bearing assembly with the 4 bolts.

    Torque:
    80 N*m{ 816 kgf*cm , 59 ft.*lbf }

  1. Connect the skid control sensor connector.

    NOTICE:
    Do not twist the sensor wire when connecting it.


2. INSPECT REAR AXLE HUB BEARING LOOSENESS

  1. C224307
    Using a dial indicator, check for looseness near the center of the axle hub.

    Maximum:
    0.05 mm (0.0020 in.)

    NOTICE:
    Ensure that the dial indicator is set perpendicular to the measurement surface.

    If looseness exceeds the maximum, replace the axle hub assembly.


3. INSPECT REAR AXLE HUB RUNOUT

  1. C224309
    Using a dial indicator, check for runout on the surface of the axle hub outside the hub bolt.

    Maximum:
    0.07 mm (0.0027 in.)

    NOTICE:
    Ensure that the dial indicator is set perpendicular to the measurement surface.

    If runout exceeds the maximum, replace the axle hub assembly.


4. INSTALL REAR DISC

  1. C143446E01
    Aligning the matchmarks, install the rear disc.

    HINT:
    When replacing the rear disc with a new one, select the installation position where the rear disc has the minimum runout.


5. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

  1. C138223
    Install the rear disc brake caliper with the 2 bolts.

    Torque:
    47 N*m{ 479 kgf*cm , 35 ft.*lbf }

    NOTICE:
    Do not twist the brake hose when installing the rear disc brake caliper assembly LH.

  1. C083014E03
    Install the rear flexible hose with the bolt.

    Torque:
    19 N*m{ 192 kgf*cm , 14 ft.*lbf }


6. INSTALL REAR WHEEL

Torque:
103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }


7. INSPECT ABS SPEED SENSOR SIGNAL
  1. ABS: Click here

  1. VSC: Click here

← INSTALLATION (Oct 2006 – May 2009)COMPONENTS (Jun 2006 – May 2009) →