2006-2011 Camry Aurion · Service Manual BRAKE

TERMINALS OF ECU

System information · Vehicles built from Jun 2006


TERMINALS OF ECU
C131974E01
Symbols (Terminal No.)
Terminal Description
GND2 (1)
Actuator pump motor ground
+BM (2)
Motor relay power supply
+BS (3)
Solenoid valves power supply
GND1 (4)
Skid control ground
FL+ (5)
Front LH (+) wheel speed signal input
FL- (6)
Front LH (-) wheel speed signal input
RL+ (7)
Rear LH (+) wheel speed signal input
RR- (8)
Rear RH (-) wheel speed signal input
FR- (9)
Front RH (-) wheel speed signal input
FR+ (10)
Front RH (+) wheel speed signal input
CANL (15)
CAN communication line L
RL- (17)
Rear LH (-) wheel speed signal input
IG1 (18)
ECU power supply
RR+ (19)
Rear RH (+) wheel speed signal input
STP (20)
Stop light switch input
SP1 (23)
Speed signal output for speedometer
TS (25)
Sensor check input
CANH (26)
CAN communication line H

TERMINAL INSPECTION

  1. Disconnect the connector and measure the voltage or resistance on the wire harness side.

    HINT:
    Voltage cannot be measured with the connector connected to the skid control ECU as the connector is watertight.

    C131969E01
    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    GND2 (1) - Body ground
    W-B - Body ground
    Actuator pump motor ground
    Always
    Below 1 Ω
    +BM (2) - Body ground
    B - Body ground
    Power supply for motor
    Always
    10 to 14 V
    +BS (3) - Body ground
    L - Body ground
    Power supply for solenoid
    Always
    10 to 14 V
    GND1 (4) - Body ground
    W-B - Body ground
    Skid control ECU ground
    Always
    Below 1 Ω
    IG1 (18) - Body ground
    P - Body ground
    ECU power supply
    Ignition switch ON
    10 to 14 V
    STP (20) - Body ground
    P - Body ground
    Stop light switch input
    Stop light switch ON
    (Brake pedal depressed)
    8 to 14 V
    STP (20) - Body ground
    P - Body ground
    Stop light switch input
    Stop light switch OFF
    (Brake pedal released)
    Below 3 V

← PROBLEM SYMPTOMS TABLE (from Jun 2009)DIAGNOSIS SYSTEM (Jun 2006 – Sep 2006) →