2006-2011 Camry Aurion · Service Manual BRAKE

DTC CHECK / CLEAR

Troubleshooting · Vehicles built from Jun 2009

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009


DTC CHECK / CLEAR (SST CHECK WIRE)

  1. G022986E01
    DTC check

    1. Using SST, connect terminals TC and CG of the DLC3.

      SST
      09843-18040  

    2. Turn the ignition switch to the ON position.

    3. Read the DTCs from the ABS warning light on the combination meter.

      HINT:
      If no code appears, inspect the TC and CG terminal circuit and the ABS warning light circuit.

      Trouble Area
      See procedure
      TC and CG terminal circuit
      Click here
      ABS warning light circuit (Remains on)
      Click here
      ABS warning light circuit (Does not come on)
      Click here

    4. As an example, refer to the chart below for the blinking patterns of the normal system code and trouble codes 11 and 21.
      I042843E01

    5. The codes are explained in the code table (Click here).

    6. After completing the check, disconnect terminals TC and CG of the DLC3, and turn off the display. If 2 or more DTCs are detected at the same time, the DTCs will be displayed in ascending order.

  2. G022986E01
    DTC clear

    1. Using SST, connect terminals TC and CG of the DLC3.

      SST
      09843-18040  

    2. Turn the ignition switch to the ON position.

    3. BR03890
      Clear the DTCs stored in the ECU by depressing the brake pedal 8 times or more within 5 seconds.

    4. Check that the warning light indicates the normal system code.

    5. Remove the SST from the terminals of the DLC3.

      HINT:
      Clearing the DTCs cannot be performed by disconnecting the battery terminal or the ECU-IG fuse.


DTC CHECK/CLEAR (WHEN USING INTELLIGENT TESTER:)

  1. C139987E01
    DTC check

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to the ON position.

    3. Read the DTCs by following the prompts on the tester screen.

  2. DTC clear

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to the ON position.

    3. Operate the intelligent tester to clear the codes.

      HINT:
      Refer to the intelligent tester operator's manual for further details.


END OF DTC CHECK/CLEAR
  1. Turn the ignition switch to the ON position.

  2. Check that the ABS warning light goes off within approximately 3 seconds.

← DTC CHECK / CLEAR (Oct 2006 – May 2009)FREEZE FRAME DATA (Jun 2006 – Sep 2006) →