DATA LIST / ACTIVE TEST
System information · Vehicles built from Jun 2006
| DATA LIST |
- HINT:
- According to the Data List displayed by the intelligent tester, the value of the switch, sensor, actuator and other items can be read without removing any parts. Reading the Data List as a first step in troubleshooting is one of the methods to save labor time.
Connect the intelligent tester to the DLC3.

Turn the ignition switch to the ON position.
According to the display on the tester, read the "Data List".
Data List: Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
ABS Warning Lamp
ABS warning light ON /OFF
ON: ABS warning light ON
OFF: ABS warning light OFF
-
Brake Warning Lamp
Brake warning light ON / OFF
ON: Brake warning light ON
OFF: Brake warning light OFF
-
Stop Lamp SW
Stop light switch / ON or OFF
ON: Brake pedal depressed
OFF: Brake pedal released
-
Parking Brake SW
Parking brake switch / ON or OFF
ON: Parking brake applied
OFF: Parking brake released
-
FR Wheel Speed
Wheel speed sensor (FR) reading / min.: 0 km/h (0 mph), max.: 326 km/h (202 mph)
Actual wheel speed
Speed indicated on speedometer
FL Wheel Speed
Wheel speed sensor (FL) reading / min.: 0 km/h (0 mph), max.: 326 km/h (202 mph)
Actual wheel speed
Speed indicated on speedometer
RR Wheel Speed
Wheel speed sensor (RR) reading / min.: 0 km/h (0 mph), max.: 326 km/h (202 mph)
Actual wheel speed
Speed indicated on speedometer
RL Wheel Speed
Wheel speed sensor (RL) reading / min.: 0 km/h (0 mph), max.: 326 km/h (202 mph)
Actual wheel speed
Speed indicated on speedometer
Vehicle Speed
Vehicle speed reading / min.: 0 km/h (0 mph), max.: 326 km/h (202 mph)
Actual wheel speed
Speed indicated on speedometer
FR Wheel Acceleration
Front right wheel acceleration / Min.: -200.84 m/s2, Max.: 199.27 m/s2
0 m/s2
-
FL Wheel Acceleration
Front left wheel acceleration / Min.: -200.84 m/s2, Max.: 199.27 m/s2
0 m/s2
-
RR Wheel Acceleration
Rear right wheel acceleration / Min.: -200.84 m/s2, Max.: 199.27 m/s2
0 m/s2
-
RL Wheel Acceleration
Rear left wheel acceleration / Min.: -200.84 m/s2, Max.: 199.27 m/s2
0 m/s2
-
FR Wheel ABS Ctrl Status
Front right ABS control status / ON or OFF
ON: During ABS control
OFF: Not ABS control
-
FL Wheel ABS Ctrl Status
Front left ABS control status / ON or OFF
ON: During ABS control
OFF: Not ABS control
-
RR Wheel ABS Ctrl Status
Rear right ABS control status / ON or OFF
ON: During ABS control
OFF: Not ABS control
-
RL Wheel ABS Ctrl Status
Rear left ABS control status / ON or OFF
ON: During ABS control
OFF: Not ABS control
-
FR Wheel EBD Ctrl Status
Front right EBD control status / ON or OFF
ON: During EBD control
OFF: Not EBD control
-
FL Wheel EBD Ctrl Status
Front left EBD control status / ON or OFF
ON: During EBD control
OFF: Not EBD control
-
RR Wheel EBD Ctrl Status
Rear right EBD control status / ON or OFF
ON: During EBD control
OFF: Not EBD control
-
RL Wheel EBD Ctrl Status
Rear left EBD control status / ON or OFF
ON: During EBD control
OFF: Not EBD control
-
Solenoid Relay
Solenoid relay / ON or OFF
ON: Solenoid relay ON
OFF: Solenoid relay OFF
-
ECB Motor Relay
ABS motor relay / ON or OFF
ON: During pump motor operation
OFF: No pump motor operation
-
ABS Solenoid (SFRH)
ABS solenoid (SFRH) ON / OFF
ON: Operates
-
ABS Solenoid (SFRR)
ABS solenoid (SFRR) ON / OFF
ON: Operates
-
ABS Solenoid (SFLH)
ABS solenoid (SFLH) ON / OFF
ON: Operates
-
ABS Solenoid (SFLR)
ABS solenoid (SFLR) ON / OFF
ON: Operates
-
ABS Solenoid (SRRH)
ABS solenoid (SRRH (SRH)) ON / OFF
ON: Operates
-
ABS Solenoid (SRRR)
ABS solenoid (SRRR (SRR)) ON / OFF
ON: Operates
-
ABS Solenoid (SRLH)
ABS solenoid (SRLH) ON / OFF
ON: Operates
-
ABS Solenoid (SRLR)
ABS solenoid (SRLR) ON / OFF
ON: Operates
-
Test Mode
Test mode / NORMAL or TEST
NORMAL: Normal mode
TEST: During test mode
-
Number of DTC
Number of DTCs recorded / min.: 0, max.: 255
Min.: 0, Max.: 19
-
IG Voltage
ECU power supply voltage / NORMAL or TOO LOW
NORMAL: 9.5 V or over
TOO LOW: Below 9.5 V
-
| ACTIVE TEST |
- HINT:
- Performing the Active Test using the intelligent tester allows the relay, actuator and other items to operate without removing any parts. Performing the Active Test as a first step in troubleshooting is one of the methods to save labor time.
- It is possible to display the Data List during the Active Test.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
According to the display on the tester, perform the "Active Test".
- HINT:
- The ignition switch must be turned ON to proceed to the Active Test using the intelligent tester.
Active Test: Tester Display
Test Part
Control Range
Diagnostic Note
ABS Warning Lamp
ABS warning light
Warning light ON / OFF
Observe combination meter
Brake Warning Lamp
Brake warning light
Warning light ON / OFF
Observe combination meter
Motor Relay
ABS motor relay
Motor relay ON / OFF
Operating sound of motor can be heard
ABS Solenoid (SRLR)
ABS solenoid (SRLR)
Solenoid ON / OFF
Operating sound of solenoid (clicking sound) can be heard
ABS Solenoid (SRLH)
ABS solenoid (SRLH)
Solenoid ON / OFF
Operating sound of solenoid (clicking sound) can be heard
ABS Solenoid (SRRR)
ABS solenoid (SRRR)
Solenoid ON / OFF
Operating sound of solenoid (clicking sound) can be heard
ABS Solenoid (SRRH)
ABS solenoid (SRRH)
Solenoid ON / OFF
Operating sound of solenoid (clicking sound) can be heard
ABS Solenoid (SFLR)
ABS solenoid (SFLR)
Solenoid ON / OFF
Operating sound of solenoid (clicking sound) can be heard
ABS Solenoid (SFLH)
ABS solenoid (SFLH)
Solenoid ON / OFF
Operating sound of solenoid (clicking sound) can be heard
ABS Solenoid (SFRR)
ABS solenoid (SFRR)
Solenoid ON / OFF
Operating sound of solenoid (clicking sound) can be heard
ABS Solenoid (SFRH)
ABS solenoid (SFRH)
Solenoid ON / OFF
Operating sound of solenoid (clicking sound) can be heard