B2313 Glass Position Initialization Incomplete
Diagnostic trouble codes · Vehicles built from Oct 2006
Versions by build date: Jun 2006 – Sep 2006 from Oct 2006
DESCRIPTION
The portion of the power window control system that is located in the driver door consists of a power window master switch, regulator, and a motor with an integrated ECU. The driver door power window regulator motor is controlled by the ECU when the power window master switch is operated (models with jam protection).When the ECU determines that the driver's door power window regulator motor assembly has not been initialized, DTC B2313 is set.
- NOTICE:
- The power window control system uses a serial communication protocol (LIN) to communicate with the main body ECU. Inspect the communication function by following HOW TO PROCEED WITH TROUBLESHOOTING. Troubleshoot the power window control system after confirming that the communication system is functioning properly.
- HINT:
- Replacing the door glass or door glass run may cause a difference to exist between the current door glass position and the position memorized in the ECU. In this case, the jam protection function may work improperly. Return the system to the pre-initialized condition and reinitialize the system.
- To return the system to the pre-initialized condition:
Disconnect the power window regulator motor connector during power window operation. This will return the motor to the pre-initialized condition.
- Replacing the door glass or door glass run may cause a difference to exist between the current door glass position and the position memorized in the ECU. In this case, the jam protection function may work improperly. Return the system to the pre-initialized condition and reinitialize the system.
| DTC Code |
DTC Detection Condition |
Trouble Area |
| B2313 |
|
|
INSPECTION PROCEDURE
- NOTICE:
- When using the intelligent tester to troubleshoot the LIN communication line: Connect the intelligent tester to the vehicle, and turn the courtesy light switch on and off at 1.5 second intervals until communication between the tester and vehicle begins.
| 1. CHECK DTC OUTPUT |
Turn the ignition switch off.
Wait for at least 10 seconds, and then turn the ignition switch on (IG).
Check whether the DTC output recurs.
- Result:
Display (DTC Output)
Proceed to
B2313
A
No output
B
|
|
||||
| A | |
| 2. SYSTEM INITIALIZE (POWER WINDOW CONTROL SYSTEM) |
Turn the ignition switch on (IG) and initialize the power window regulator motor (on the driver side) (Click here).
Turn the ignition switch off.
Wait for at least 10 seconds, and then turn the ignition switch ON.
Check whether the DTC output recurs.
- Result:
Display (DTC Output)
Proceed to
No output
A
B2313
B
|
|
||||
| A | ||
| ||
