Taillight Relay Circuit
Circuit diagnosis · Vehicles built Oct 2006 – May 2009
Versions by build date: Oct 2006 – May 2009 from Jun 2009
DESCRIPTION
The main body ECU receives a signal from the headlight dimmer switch assembly, and turns the taillight relay on.WIRING DIAGRAM




INSPECTION PROCEDURE
| 1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the intelligent tester main switch on.
Select the item below in the ACTIVE TEST and then check that the relay operates.
Main Body (Main Body ECU): Tester Display
Test Part
Control Range
Diagnostic Note
Taillight Relay
Taillight relay
ON / OFF
-
- OK:
- Taillight relay operates. (Taillights illuminate.)
|
|
||||
| NG | |
| 2. INSPECT FUSE (TAIL) |
Remove the TAIL fuse from the instrument panel J/B assembly.
Measure the resistance of the fuse.
- Standard resistance:
- Below 1 Ω
|
|
||||
| OK | |
| 3. INSPECT TAILLIGHT RELAY |
Remove the taillight relay from the instrument panel J/B assembly.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Specified Condition
3 - 5
10 kΩ or higher
Below 1 Ω (When battery voltage is applied to terminals 1 and 2)
3 - 4
Below 1 Ω
10 kΩ or higher (When battery voltage is applied to terminals 1 and 2)
|
|
||||
| OK | |
| 4. INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY |
Measure the voltage according to the value(s) in the table below.

- Standard voltage:
Tester Connection
Condition
Specified Condition
IC-4 - Body ground
Ignition switch ON, light control switch OFF → TAIL
Below 1 V → 10 to 14 V
IC-5 - Body ground
Ignition switch ON, light control switch OFF → TAIL
Below 1 V → 10 to 14 V
IP-8 - Body ground
Ignition switch ON, light control switch OFF → TAIL
Below 1 V → 10 to 14 V
|
|
||||
| NG | |
| 5. CHECK HARNESS AND CONNECTOR (BATTERY - INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY) |
Disconnect the IA instrument panel J/B assembly connector.

Measure the voltage according to the value(s) in the table below.
- Standard voltage:
Tester Connection
Condition
Specified Condition
IA-1 - Body ground
Always
10 to 14 V
|
|
||||
| OK | ||
| ||
