2006-2011 Camry Aurion · Service Manual BRAKE

TERMINALS OF ECU

System information · Vehicles built Jun 2006 – Sep 2006

Versions by build date: Jun 2006 – Sep 2006 from Oct 2006


TERMINALS OF ECU
C113404E09
Symbols (Terminal No.)
Terminal Description
GND2 (1)
Skid control ECU ground
+BM (2)
Power supply for motor
+BS (3)
Power supply for solenoid
GND1 (4)
Skid control ECU ground
FL+ (5)
Front left wheel speed sensor input
FL- (6)
Front left wheel speed sensor ground
RL+ (7)
Rear left wheel speed sensor input
RR- (8)
Rear right wheel speed sensor ground
FR- (9)
Front right wheel speed sensor ground
FR+ (10)
Front right wheel speed sensor input
CANL (14)
CAN communication line L
BZ (23)
Buzzer output
RL- (27)
Rear left wheel speed sensor ground
IG1 (28)
ECU power supply
RR+ (29)
Rear right wheel speed sensor input
STP1 (30)
Stop light switch input
SP1 (33)
Speed signal output
CANH (35)
CAN communication line H
TS (39)
Sensor check switch input

TERMINAL INSPECTION

  1. Disconnect the connector and measure the voltage and resistance according to the value(s) in the table below.
    C137467E02

    HINT:
    Voltage cannot be measured with the connector connected to the skid control ECU, as the connector is watertight.

    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    GND2 (1) - Body ground
    W-B - Body ground
    Actuator pump motor ground
    Always
    Below 1 Ω
    +BM (2) - Body ground
    B - Body ground
    Power supply for motor
    Always
    10 to 14 V
    +BS (3) - Body ground
    L - Body ground
    Power supply for solenoid
    Always
    10 to 14 V
    GND1 (4) - Body ground
    W-B - Body ground
    Skid control ECU ground
    Always
    Below 1 Ω
    BZ (23) - Body ground
    R - Body ground
    Buzzer warning light output
    Ignition switch ON, Buzzer does not sound
    6 to 10 V
    IG1 (28) - Body ground
    P - Body ground
    IG1 power supply
    Ignition switch ON
    10 to 14 V
    STP1 (30) - Body ground
    P - Body ground
    Stop light switch input
    Stop light switch ON (Brake pedal depressed)
    5 to 14 V
    STP1 (30) - Body ground
    P - Body ground
    Stop light switch input
    Stop light switch OFF (Brake pedal released)
    Below 3 V

← PROBLEM SYMPTOMS TABLE (from Jun 2009)TERMINALS OF ECU (from Oct 2006) →