TS and CG Terminal Circuit
Circuit diagnosis · Vehicles built from Jun 2006
DESCRIPTION
In the Test Mode (signal check), a malfunction of the speed sensor that cannot be detected when the vehicle is stopped can be detected while driving.Transition to the sensor check mode can be performed by connecting terminals TS and CG of the DLC3 and turning the ignition switch from off to ON.
WIRING DIAGRAM


INSPECTION PROCEDURE
- HINT:
- Check the condition of each related circuit connector before troubleshooting (Click here).
| 1. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU TO DLC3) |
Disconnect the skid control ECU connector.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
A26-39 (TS) - E10-12 (TS)
Always
Below 1 Ω
Connect the connector.
|
|
||||
| OK | |
| 2. CHECK HARNESS AND CONNECTOR (DLC3 TO BODY GROUND) |
Measure the resistance according to the value(s) in the table below.

- Standard resistance:
Tester Connection
Condition
Specified Condition
E10-4 (CG) - Body ground
Always
Below 1 Ω
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (TS TERMINAL CIRCUIT) |
Measure the resistance according to the value(s) in the table below.

- Standard resistance:
Tester Connection
Condition
Specified Condition
E10-12 (TS) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
