2006-2011 Camry Aurion · Service Manual ENGINE

DISASSEMBLY

Removal / installation · Vehicles built Oct 2006 – May 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009


1. REMOVE GENERATOR CLUTCH PULLEY

  1. A128068E01
    Using a screwdriver, remove the generator pulley cap.

  1. A128069E01
    Set SST (A) and (B).
    SST
    09820-63020  

  1. Clamp SST (A) in a vise.

  1. A135194E01
    Place the rotor shaft end into SST (A).

  1. A135195E01
    Fit SST (B) to the clutch pulley.

  1. A135196E01
    Loosen the pulley by turning SST (B) in the direction shown in the illustration.

  1. Remove the generator assembly from the SST.

  1. Remove the clutch pulley from the rotor shaft.


2. REMOVE GENERATOR REAR END COVER

  1. A135197
    Place the generator assembly on the clutch pulley.

  1. A128071
    Remove the 3 nuts and generator rear end cover.


3. REMOVE GENERATOR TERMINAL INSULATOR

  1. A128072
    Remove the terminal insulator from the generator coil.


4. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY

  1. A128073
    Remove the 2 screws and brush holder from the generator coil.


5. REMOVE GENERATOR COIL ASSEMBLY

  1. A128074
    Remove the 4 bolts.

  1. A118275E01
    Using SST, remove the generator coil assembly.
    SST
    09950-40011   (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04071, 09957-04010, 09958-04011)


6. REMOVE GENERATOR ROTOR ASSEMBLY

  1. A118365E01
    Remove the generator washer.

  1. A118367E01
    Remove the generator rotor assembly.


7. REMOVE GENERATOR DRIVE END FRAME BEARING

  1. A128076
    Remove the 4 screws and retainer plate from the drive end frame.

  1. A128077E01
    Using SST and a hammer, tap out the drive end frame bearing from the drive end frame.
    SST
    09950-60010   (09951-00250)
    09950-70010   (09951-07100)

← REMOVAL (from Jun 2009)DISASSEMBLY (from Jun 2009) →