The torque shown above should be used for tightening without using SST. When the SST is used for tightening, the torque should be calculated based on the length of the SST (Click here).
2.
INSTALL HEATED OXYGEN SENSOR (for Bank 1)
Using SST, install the heated oxygen sensor.
SST
09224-00010
Torque:
44 N*m{
449 kgf*cm
, 32 ft.*lbf
}
NOTICE:
The torque shown above should be used for tightening without using SST. When the SST is used for tightening, the torque should be calculated based on the length of the SST (Click here).
3.
INSTALL FRONT EXHAUST PIPE ASSEMBLY
Install 2 new gaskets to the exhaust front pipe.
Install the exhaust front pipe to the exhaust manifolds with the 2 nuts and 2 bolts.