2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

INSPECTION

Inspection · Vehicles built from Jun 2006


INSPECT FRONT DOOR LOCK LH ASSEMBLY
  1. Remove the front door lock assembly LH.

  1. B065427E20
    Check operation of the door lock motor.

    1. Apply battery voltage and check operation of the door lock motor.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 4
      Battery negative (-) → Terminal 1
      Lock
      Battery positive (+) → Terminal 1
      Battery negative (-) → Terminal 4
      Unlock

  1. B065428E11
    Check operation of the door key lock and unlock switch.

    1. Measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      7 - 9
      ON (Door lock set to LOCK)
      Below 1 Ω
      7 - 9
      7 - 10
      OFF (Free)
      10 kΩ or higher
      7 - 10
      ON (Door lock set to UNLOCK)
      Below 1 Ω

  1. B065427E20
    Check operation of the door unlock detection switch.

    1. Measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Measurement Condition
      Door Lock Condition
      Specified Condition
      7 - 8
      Battery positive (+) → Terminal 4
      Battery negative (-) → Terminal 1
      Lock
      10 kΩ or higher
      7 - 8
      Battery positive (+) → Terminal 1
      Battery negative (-) → Terminal 4
      Unlock
      Below 1 Ω


INSPECT FRONT DOOR LOCK RH ASSEMBLY
  1. Remove the front door lock assembly RH.

  1. B065429E21
    Check operation of the door lock motor.

    1. Apply battery voltage and check operation of the door lock motor.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 4
      Battery negative (-) → Terminal 1
      Lock
      Battery positive (+) → Terminal 1
      Battery negative (-) → Terminal 4
      Unlock

  1. B112613E01
    Check operation of the door key lock and unlock switch.

    1. Measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      5 - 8
      ON
      (Door lock set to UNLOCK)
      Below 1 Ω
      5 - 8
      6 - 8
      OFF (Free)
      10 kΩ or higher
      6 - 8
      ON
      (Door lock set to LOCK)
      Below 1 Ω

  1. B065429E21
    Check operation of the door unlock detection switch.

    1. Measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Measurement Condition
      Door Lock Condition
      Specified Condition
      7 - 8
      Battery positive (+) → Terminal 4
      Battery negative (-) → Terminal 1
      Lock
      10 kΩ or higher
      7 - 8
      Battery positive (+) → Terminal 1
      Battery negative (-) → Terminal 4
      Unlock
      Below 1 Ω

← REMOVAL (from Jun 2009)INSTALLATION (Jun 2006 – Sep 2006) →