When reusing the removed rear door lock assembly, replace the door lock wiring harness seal on the connector with a new one.
Do not allow grease or dust to adhere to the door lock wiring harness seal surface of the connector.
Reusing the door lock wiring harness seal or using a damaged door lock wiring harness seal may cause water intrusion to the connection. This may result in a malfunction of the rear door lock assembly.
Install the rear door inside locking cable assembly.
Engage the 3 claws.
Install the rear door lock remote control cable assembly.
Engage the claw.
Apply MP grease to the sliding parts of the rear door lock assembly.
Install a new door lock wiring harness seal to the rear door lock assembly.
Insert the rear door lock assembly into the rear door outside handle release plate, and set it to the rear door panel.
Make sure that the rear door outside handle frame release plate is securely connected to the rear door lock assembly.
Using a "TORX" socket wrench (T30), install the rear door lock assembly with the 3 screws.
Torque:
5.0 N*m{
51 kgf*cm
, 44 in.*lbf
}
Connect the connector.
2.
INSTALL REAR DOOR SERVICE HOLE COVER
Apply butyl tape to the rear door panel.
Pass the rear door lock remote control cable, rear door inside locking cable and each connector through a new rear door service hole cover.
Install a new rear door service hole cover.
NOTICE:
Securely install the rear door service hole cover avoiding wrinkles and air bubbles.
Connect the connector and clamp.
3.
INSTALL REAR DOOR INSIDE HANDLE SUB-ASSEMBLY
Connect the rear door lock remote control cable and rear door inside locking cable to the rear door inside handle.
Engage the 2 claws and install the rear door inside handle sub-assembly.
4.
INSTALL REAR DOOR INNER GLASS WEATHERSTRIP
Engage the 3 claws to install the rear door inner glass weatherstrip.
5.
INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY
Engage the claw to install the No. 1 door scuff plate clamp.
Connect each connector.
Engage the rear door trim board with the 4 clips of the rear door inner glass weatherstrip.
Engage the 7 clips to install the rear door trim board to the rear door panel.