2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

Certification ECU Power Source Circuit

Circuit diagnosis · Vehicles built from Jun 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009

DESCRIPTION

This is the power source circuit of the certification ECU.
The certification ECU controls the following:
  1. Electrical key verification confirmation
  2. Cabin and door oscillator control
  3. Entry door LOCK/UNLOCK request to the main body ECU
  4. Steering LOCK/UNLOCK request
  5. Immobiliser SET/UNSET request to the ID code box

WIRING DIAGRAM

B150906E01

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT)

  1. B137963E17
    Disconnect the E58 certification ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection (Symbols)
    Condition
    Specified Condition
    E58-1 (+B) - Body ground
    Always
    10 to 14 V
    E58-18 (IG) - Body ground
    Engine switch OFF
    Below 1 V
    Engine switch ON (IG)
    10 to 14 V
    E58-19 (ACC) - Body ground
    Engine switch OFF
    Below 1 V
    Engine switch ON (ACC)
    10 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection (Symbols)
    Condition
    Specified Condition
    E58-17 (E) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Certification ECU Power Source Circuit (Oct 2006 – May 2009)PRECAUTION (Oct 2006 – May 2009) →