2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

Door Courtesy Switch Circuit

Circuit diagnosis · Vehicles built from Jun 2009

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009

DESCRIPTION

The main body ECU (instrument panel J/B) detects the condition of the front door courtesy light switch assembly (driver's side).

WIRING DIAGRAM

B150853E06

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER

  1. B139188E02
    Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to the ON position and turn the intelligent tester main switch on.

  1. Select Door Courtesy SW in the Data List and read the tester display.

    BODY: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    D Door Courtesy SW
    Driver's side door courtesy switch signal/ON or OFF
    ON: Driver's side door is open
    OFF: Driver's side door is closed
    -

    OK:
    ON or OFF appears on the screen according to the driver's side door condition.



OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
NG


2. INSPECT FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY

  1. B111600E02
    Remove the driver's side front door courtesy light switch (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - Switch body
    Courtesy switch pushed (Door closed)
    10 kΩ or higher
    Courtesy switch free (Door open)
    Below 1 Ω



NG
REPLACE FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY (Click here)
OK


3. CHECK HARNESS AND CONNECTOR (FRONT DOOR COURTESY LIGHT SWITCH - MAIN BODY ECU)

  1. B139169E06
    Disconnect the E7 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    N6-1 (*1) - E7-24 (DCTY)
    Always
    Below 1 Ω
    O6-1 (*2) - E7-24 (DCTY)
    N6-1 (*1) - Body ground
    10 kΩ or higher
    O6-1 (*2) - Body ground

    *1: for LHD *2: for RHD



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Door Courtesy Switch Circuit (Oct 2006 – May 2009)Unlock Warning Switch Circuit (Jun 2006 – Sep 2006) →