TERMINALS OF ECU
System information · Vehicles built from Jun 2009
Versions by build date: Jun 2006 – May 2009 from Jun 2009
| CHECK MAIN BODY ECU (INSTRUMENT PANEL J/B) |
Disconnect the main body ECU (instrument panel J/B) connectors.


Measure the resistance and voltage between each terminal of the wire harness side connectors and body ground.
Symbols (Terminal No.)
Wiring Color
Terminal Description
Condition
Specified Condition
TSW (E6-2) - Body ground*1
TKUL (E6-2) - Body ground*2
R - Body ground
Luggage compartment door key-linked door unlock input
Using mechanical key, operate luggage compartment door lock cylinder to LOCK → OPEN → UNLOCK
10 kΩ or higher → Below 1 Ω → 10 kΩ or higher
RCTY (E6-5) - Body ground
GR - Body ground
Rear courtesy light switch RH input
Rear door RH CLOSED (OFF) → OPEN (ON)
10 kΩ or higher → Below 1 Ω
PCTY (E6-21) - Body ground
L - Body ground
Passenger side courtesy light switch input
Passenger side door CLOSED (OFF) → OPEN (ON)
10 kΩ or higher → Below 1 Ω
LGCY (E6-25) - Body ground
W - Body ground
Luggage compartment door courtesy light switch input
Luggage compartment door CLOSED (OFF) → OPEN (ON)
10 kΩ or higher → Below 1 Ω
HCTY (E7-16) - Body ground
R - Body ground
Engine hood courtesy switch
Engine hood CLOSED (OFF) → OPEN (ON)
10 kΩ or higher → Below 1 Ω
DCTY (E7-24) - Body ground
Y - Body ground
Driver side door courtesy light switch input
Driver side door CLOSED (OFF) → OPEN (ON)
10 kΩ or higher → Below 1 Ω
KSW (E9-5) - Body ground
B - Body ground
Unlock warning switch input
No key in ignition key cylinder (OFF) → Key inserted (ON)
10 kΩ or higher → Below 1 Ω
ACC (IF-2) - Body ground
L - Body ground
Ignition power supply (ACC signal)
Ignition switch ACC → OFF
10 to 14 V → Below 1 V
IG (IF-11) - Body ground
B - Body ground
Ignition power supply (IG signal)
Ignition switch ON → OFF
10 to 14 V → Below 1 V
ALTB (ID-16) - Body ground
W - Body ground
+B (power system alternator system) power supply
Always
10 to 14 V
GND1 (IF-10) - Body ground
W-B - Body ground
Ground
Always
Below 1 Ω
BECU (ID-10) - Body ground
BE - Body ground
+B power supply
Always
10 to 14 V
GND2 (IM-9) - Body ground
W-B - Body ground
Ground
Always
Below 1 Ω
LCTY (IO-7) - Body ground
LG - Body ground
Rear courtesy light switch LH input
Rear door LH CLOSED (OFF) → OPEN (ON)
10 kΩ or higher → Below 1 Ω
- *1: for 2GR-FE
- *2: for 2ZA-FE
- *1: for 2GR-FE
Reconnect the main body ECU (instrument panel J/B) connectors.
Measure the voltage between each terminal of the wire harness side connectors and body ground.
If the result is not as specified, the main body ECU (instrument panel J/B) may have a malfunction.Symbols (Terminal No.)
Wiring Color
Terminal Description
Condition
Specified Condition
HAZ (E8-4) - Body ground
W - Body ground
Turn signal flasher relay signal
System is in alarm sounding state
Pulse generation
(0 V ← → 12 V)
IND (E9-4) - Body ground
Y - Body ground
Security indicator output
Security indicator lights up
(It lights up only for 30 sec. in alarm sounding state. It flashes when immobiliser is operating.)
3 to 6 V
SH (E9-6) - Body ground
P - Body ground
Security horn drive
Security horn is sounding
(Theft deterrent system is in alarm sounding state)
Pulse generation
(0 V ← → 12 V)
HORN (ID-11) - Body ground
B - Body ground
Vehicle horn drive
Vehicle horn is sounding
(Theft deterrent system is in alarm sounding state)
Pulse generation
(0 V ← → 12 V)