2006-2011 Camry Aurion · Service Manual STEERING

INITIALIZATION

Troubleshooting · Vehicles built from Oct 2006

HINT:
In vehicles equipped with the smart entry and start system function, the starting function may not operate after recharging or while jump-starting a discharged battery. This condition is most common if the battery voltage drops below 9 V. The following procedure has been developed to address this condition.


INITIALIZATION PROCEDURE
C113506E02
  1. Confirm that the short pin is installed.

    HINT:
    If the short pin is not installed, install it at this time.

  2. Move the shift lever to the P position.

  3. Turn the engine switch off.

  4. Open the driver's door.

    HINT:
    Opening the driver's door will start an initialization process between the steering lock ECU and the engine room J/B.

  5. Depress the brake pedal.

  6. Press the "START STOP" switch.

← HOW TO PROCEED WITH TROUBLESHOOTING (from Jun 2009)PROBLEM SYMPTOMS TABLE (Oct 2006 – May 2009) →