2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation · Vehicles built from Jun 2009

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009


1. REMOVE FRONT BUMPER ASSEMBLY (for 2AZ-FE)

  1. B220943E01
    Put protective tape around the front bumper assembly.

  1. B138884E01
    Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. B220944
    Remove the 8 screws, 2 clips, 2 radiator grille protectors and bolt.

  1. B220945
    Disengage the 2 claws and disconnect the front bumper assembly as shown in the illustration.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. w/o Fog Light:

    1. Remove the front bumper assembly.

  1. w/ Fog Light:

    1. Disconnect each connector, and then remove the front bumper assembly.


2. REMOVE COOL AIR INTAKE DUCT SEAL (for 2GR-FE)

  1. B232362
    Remove the 7 clips and cool air intake duct seal.


3. REMOVE FRONT BUMPER ASSEMBLY (for 2GR-FE)

  1. B232367E01
    Put protective tape around the front bumper assembly.

  1. B149626E01
    Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. B232368
    Remove the 8 screws, 3 clips and 2 radiator grille protectors.

  1. B232369
    Disengage the 2 claws and disconnect the front bumper assembly as shown in the illustration.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. w/ Clearance Sonar System:

    1. Disconnect the 2 connectors.

  1. w/ Fog Light:

    1. Disconnect the 2 connectors.

  1. w/ Headlight Cleaner System:

    1. Disconnect the 2 connectors.

    2. B149621
      Disconnect the headlight cleaner washer hose, and then remove the front bumper assembly.

  1. Remove the front bumper assembly.


4. REMOVE FOG LIGHT ASSEMBLY (for 2AZ-FE)

  1. E128199
    Remove the screw and the fog light assembly.


5. REMOVE FOG LIGHT ASSEMBLY (for 2GR-FE)

  1. E134242
    Remove the screw and the fog light assembly.

← REMOVAL (Oct 2006 – May 2009)DISASSEMBLY (from Jun 2006) →