Do not remove the radiator cap sub-assembly while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.
Remove the radiator cap sub-assembly from the radiator assembly.
Loosen the radiator drain cock plug and 2 cylinder block drain cock plugs, then drain the coolant.
HINT:
Collect the coolant in a container and dispose of it according to the regulations in your area.
5.
DRAIN ENGINE OIL
Remove the oil filler cap.
Remove the oil drain plug and drain the oil into a container.
Clean the oil drain plug.
Install the oil drain plug with a new gasket.
Torque:
40 N*m{
408 kgf*cm
, 30 ft.*lbf
}
6.
REMOVE NO. 2 MANIFOLD STAY
Remove the bolt, nut, and No. 2 manifold stay.
7.
REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR
Remove the 3 bolts and No. 2 exhaust manifold heat insulator.
8.
REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH
Uniformly loosen and remove the 6 nuts.
Remove the manifold and gasket.
9.
REMOVE ENGINE OIL COOLER
Remove the bolt, 2 clamps, and 4 clips and disconnect the 2 water by-pass hoses.
Remove the oil cooler union bolt, oil cooler assembly, and O-ring.