ON-VEHICLE INSPECTION
Inspection · Vehicles built from Jun 2006
| CHECK ENGINE OIL LEVEL |
Warm up the engine, stop the engine and wait for 5 minutes.
Check that the engine oil level is between the L and F marks of the oil dipstick.
If low, check for leakage and add oil up to the F mark.- NOTICE:
- Do not add engine oil above the F mark.
| CHECK ENGINE OIL QUALITY |
Check the oil for deterioration, water intrusion, discoloration or thinning.
If the quality is visibly poor, replace the oil.- Standard Oil Grade:
Oil Grade
Oil Viscosity (SAE)
API grade SL "Energy - Conserving", SM "Energy - Conserving" or ILSAC multigrade engine oil
- 5W-30
- 10W-30
API grade SL or SM multigrade engine oil
- 15W-40
- 20W-50
- 5W-30
| CHECK OIL PRESSURE |
Disconnect the oil pressure switch connector.
Using a 24 mm deep socket wrench, remove the oil pressure switch.

Install the oil pressure gauge.

Warm up the engine.
Measure the oil pressure.
- Standard oil pressure:
Condition
Specified Condition
Idle
29 kPa (0.3 kgf/cm2, 4.3 psi) or more
3,000 rpm
170 to 300 kPa (1.7 to 3.1 kgf/cm2, 24 to 44 psi)
Apply adhesive to 2 or 3 threads of the oil pressure switch.

- Adhesive:
- Toyota Genuine Adhesive 1344, Three Bond 1344 or Equivalent
Using a 24 mm deep socket wrench, install the oil pressure switch.
- Torque:
- 15 N*m{ 153 kgf*cm , 11 ft.*lbf }
- NOTICE:
- Do not start the engine within 1 hour of installation.
Connect the oil pressure switch connector.
Check for engine oil leaks.
