TERMINALS OF ECU
System information · Vehicles built from Jun 2006
| CHECK WINDSHIELD WIPER RELAY ASSEMBLY (AUTO WIPER RELAY) |


Disconnect the E26 relay connector.
Measure the voltage and resistance of the wire harness side connector.
If the result is not as specified, there may be a malfunction on the wire harness side.Symbols (Terminal No.)
Wiring Color
Terminal Description
Condition
Specified Condition
W (E26-4) - Body ground
GR - Body ground
Front washer switch circuit
Front washer switch is ON
Below 1 Ω
Front washer switch is OFF
10 kΩ or higher
IG (E26-12) - Body ground
L - Body ground
IG signal circuit
Ignition switch ON
10 to 14 V
Ignition switch OFF
Below 1 V
WIG (E26-23) - Body ground
B - Body ground
WIG signal circuit
Ignition switch ON
10 to 14 V
Ignition switch OFF
Below 1 V
E (E26-26) - Body ground
W-B - Body ground
Body ground
Always
Below 1 Ω
Reconnect the E26 relay connector.
Measure the voltage of the connector.
If the result is not as specified, the relay may have a malfunction.Symbols (Terminal No.)
Wiring Color
Terminal Description
Condition
Specified Condition
+2S (E26-1) - Body ground
P - Body ground
Front wiper LO speed signal circuit
Ignition switch ON,
front wiper switch LO
10 to 14 V
Ignition switch ON,
front wiper switch except LO
Below 1 V
+1 (E26-2) - Body ground
R - Body ground
Front wiper motor LO speed signal circuit
Front wiper motor is in LO operation
10 to 14 V
Front wiper motor is OFF
Below 1 V
+2 (E26-3) - Body ground
V - Body ground
Front wiper motor HI speed signal circuit
Front wiper motor is in HI operation
10 to 14 V
Front wiper motor is OFF
Below 1 V
W (E26-4) - Body ground
GR - Body ground
Front washer motor circuit
Front washer switch is ON
Below 1 V
Front washer switch is OFF
10 to 14 V
+SM (E26-10) - Body ground
Y- Body ground
Front wiper motor operation signal
Front wiper motor is in LO or HI operation
10 to 14 V
Front wiper motor is OFF
Below 1 V
C1 (E26-17) - CO (E26-16)
P - R
IG signal circuit
Ignition switch ON
10 to 14 V
Ignition switch OFF
Below 1 V