2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation · Vehicles built Oct 2006 – May 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009


1. REMOVE FRONT DOOR SCUFF PLATE LH

  1. B132067
    Disengage the 7 claws and 3 clips, and remove the front door scuff plate LH.


2. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH

  1. B132116E01
    Remove the cowl side trim clip.

  1. Disengage the 2 clips and remove the cowl side trim sub-assembly LH.


3. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

  1. B147264
    Remove the screw and the bolt.

  1. Disconnect the hood lock control cable assembly.

  1. Disengage the claw and the 4 clips.

  1. Disengage the 2 claws and disconnect the connector.

  1. Remove the air hose, disconnect the connector, and then remove the lower No. 1 instrument panel finish panel.


4. REMOVE STEERING COLUMN COVER

  1. E128001
    Turn the steering wheel assembly to the right and remove the screw as shown in the illustration.

  1. E128002
    Turn the steering wheel assembly to the left and remove the screw as shown in the illustration.

  1. E128003
    Disengage the 2 claws and remove the steering column cover lower.

  1. E136753
    Disengage the claw and remove the steering column cover upper.


5. REMOVE NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY (for LHD)

  1. B149938
    Disengage the 3 claws and the 2 clips.

  1. Disconnect each connector and remove the No. 1 instrument panel sub-assembly.


6. REMOVE NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY (for RHD)

  1. B149936
    Disengage the 3 claws and the 2 clips.

  1. Disconnect the connector and remove the No. 1 instrument panel sub-assembly.


7. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (w/o Smart Entry and Start System)

  1. B144612
    Disengage the 2 claws and 2 clips, and then remove the lower instrument panel finish panel.


8. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (w/ Smart Entry and Start System)

  1. B159330
    Disengage the 2 claws and 2 clips, and then remove the lower instrument panel finish panel.

  1. Disconnect the connector.


9. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

  1. E128011E01
    Remove the 2 clips.

  1. Disengage the guide and 4 claws, and then remove the instrument cluster finish panel sub-assembly.


10. REMOVE COMBINATION METER ASSEMBLY
  1. Using the tilt and telescopic functions, fully lower and extend the steering wheel.

  1. E136754
    Remove the 4 screws.

  1. Disconnect the connector.

  1. E128009
    Remove the combination meter assembly as shown in the illustration.


11. REMOVE TURN SIGNAL FLASHER ASSEMBLY

  1. E128235E01
    Disconnect the connector.

  1. Remove the clamp and the turn signal flasher assembly.

← ON-VEHICLE INSPECTION (from Oct 2006)REMOVAL (from Jun 2009) →