2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

5C-40 Camera Picture Error

Diagnostic trouble codes · Vehicles built Oct 2006 – May 2009

DESCRIPTION

DTC No.
DTC Detection Condition
Trouble Area
5C-40
Synchronous signal from the camera cannot be transmitted.
  1. Wire harness
  2. Television camera assembly
  3. Navigation receiver assembly

WIRING DIAGRAM

E131098E10

INSPECTION PROCEDURE

HINT:
After the inspection is completed, clear the DTCs.


1. CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - TELEVISION CAMERA ASSEMBLY)
  1. Disconnect the F12 connector from the navigation receiver assembly.

  1. Disconnect the S17 connector from the television camera assembly.E141014E03

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection (Terminal No.)
    Condition
    Specified Condition
    CB+ (S17-4) - CA+ (F12-24)
    Always
    Below 1 Ω
    CGND (S17-3) - CGND (F12-21)
    Always
    Below 1 Ω
    CV+ (S17-2) - V+ (F12-22)
    Always
    Below 1 Ω
    CV- (S17-1) - V- (F12-23)
    Always
    Below 1 Ω
    CB+ (S17-4) - Body ground
    Always
    10 kΩ or higher
    CGND (S17-3) - Body ground
    Always
    10 kΩ or higher
    CV+ (S17-2) - Body ground
    Always
    10 kΩ or higher
    CV- (S17-1) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. INSPECT NAVIGATION RECEIVER ASSEMBLY

  1. Reconnect the navigation receiver assembly connector.E134718E01

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection (Terminal No.)
    Condition
    Specified Condition
    CB+ (S17-4) - CGND (S17-3)
    Ignition switch on (IG), shift lever in R
    Approx. 6 V



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY
OK


3. INSPECT TELEVISION CAMERA ASSEMBLY

  1. Reconnect the navigation receiver assembly F12 connector and the television camera assembly S17 connector.E134719E01

  1. E119731E02
    Check the waveform of the television camera assembly using an oscilloscope.
    1. Measurement terminal: CV+ - CV-Measurement setting: 0.2 V/DIV, 0.2 μs/DIVCondition: Ignition switch on (IG), shift lever in R

      OK:
      Pulses as shown in the illustration.



NG
REPLACE TELEVISION CAMERA ASSEMBLY
OK

REPLACE NAVIGATION RECEIVER ASSEMBLY


← 58-45 High Temperature (+ 80-45) (Jun 2006 – May 2009)60-10 AM Tuner PLL does not Lock (+ 60-11) (Jun 2006 – May 2009) →