ON-VEHICLE INSPECTION
Inspection · Vehicles built from Jun 2009
| INSPECT REAR OUTER COMBINATION LIGHT ASSEMBLY |
Disconnect the connector from the rear outer combination light.

Measure the voltage according to the value(s) in the table below.
- Standard voltage:
- LH Side:
Tester Connection
Condition
Specified Condition
S11-1 - S11-3
Brake pedal released → depressed
Below 1 V → 10 to 14 V
S11-1 - S11-2
Light control switch OFF → TAIL
Below 1 V → 10 to 14 V
- RH Side:
Tester Connection
Condition
Specified Condition
S12-1 - S12-3
Brake pedal released → depressed
Below 1 V → 10 to 14 V
S12-1 - S12-2
Light control switch OFF → TAIL
Below 1 V → 10 to 14 V
| INSPECT REAR INNER COMBINATION LIGHT ASSEMBLY |
Disconnect the connector from the rear inner combination light.

Measure the voltage according to the value(s) in the table below.
- Standard voltage:
- LH Side:
Tester Connection
Condition
Specified Condition
S3-1 - S3-3
Light control switch OFF → TAIL
Below 1 V → 10 to 14 V
- RH Side:
Tester Connection
Condition
Specified Condition
S2-1 - S2-3
Light control switch OFF → TAIL
Below 1 V → 10 to 14 V
